Press grooved ball bearing out of rubber mount of propeller shaft, press in - AR41.10-P-0100-02TX

Fig 1: Identifying Press Out/In Tool (116 589 09 43 00)

Courtesy of MERCEDES-BENZ USA

Press out 

1. Use the removal and installation tool (04a, 04b) to press the grooved ball bearing (8) out of the rubber mount (7b).
   Fig 2: Identifying Rubber Mount And Ball Bearing

   Courtesy of MERCEDES-BENZ USA

   Pressing in 

2. Press deep-groove ball bearing (8) into rubberized bearing seat as far as the contact surface (arrows) using press out/in tool.

   Pay attention to correct seat of grooved ball bearing (8).

   Fig 3: Identifying Deep-Groove Ball Bearing

   Courtesy of MERCEDES-BENZ USA