Prepare electronic propeller shaft inclinometer - AR41.10-P-0086-02P
Switching on meter
- Switch on electronic propeller shaft articulation angle meter To do this, press the ON button.
The version and the serial number are displayed for several seconds. Either the selection menu or main menu then appears, depending on which meter you are using
Start screen
Courtesy of MERCEDES-BENZ USA
Electronic driveline inclinometer
- Press "STEP" button.
"Inclination angle" "Measurement" is selected.
Selection menu screen
Courtesy of MERCEDES-BENZ USA
Erasing memory
The "Erase memory" function allows you to erase the memory before measuring an angle for the second time. But this is not absolutely essential, as after the first angle is stored the angles from the previous measurement are erased from the memory. The memory is likewise erased if the measuring instrument is switched off in the meantime.
- Press the "MEMORY" button.
The values saved in the memory are displayed.
Main menu screen
Courtesy of MERCEDES-BENZ USA
The values of the preceding articulation angle measurement are displayed.
- Press "SAVE" button.
Memory screen
Courtesy of MERCEDES-BENZ USA
You are asked to confirm that you want to erase the memory before the values are actually deleted.
- Press "STEP" button.
The memory is erased.
Inquiry screen
Courtesy of MERCEDES-BENZ USA
The confirmation that you want to erase the memory is displayed for a short time. The main menu then appears again.
Confirmation screen
Courtesy of MERCEDES-BENZ USA