LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> C350 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Entertainment, Lighting & Navigation - Retrofitting & Conversion - C63/C350 (204) >> Retrofitting & Conversion >> Retrofit MOST fiber optic cable wiring harness - AN82.61-P-0001-06FHA

Retrofit MOST fiber optic cable wiring harness - AN82.61-P-0001-06FHA

  1. Connect black 2-pin coupling (16) of optical fiber wiring harness (17) to media interface control unit (N125/1).
    Fig 1: Identifying Black 2-Pin Coupling, Optical Fiber Wiring Harness And Media Interface Control Unit
    G07528523Courtesy of MERCEDES-BENZ USA
  2. Route optical fiber wiring harness (17), as shown, from installation location (arrow C) of media interface control unit into slot of audio equipment.
  3. Fasten optical fiber wiring harness (17) using cable ties to vehicle wiring harness.
    Fig 2: Identifying Optical Fiber Wiring Harness Installation Position
    G07528524Courtesy of MERCEDES-BENZ USA
    Fig 3: Identifying Connector, On-Board Optical Fiber And Black 44-Pin Coupling
    G07528525Courtesy of MERCEDES-BENZ USA
  4. Remove connector (20) of on-board optical fiber (22) from black 44-pin coupling (21).
  5. Remove blue fuse (18) from coupling (20) of on-board optical fiber (22).
  6. Remove optical fiber (22.1) of on-board optical fiber (22) from input of contact cavity (arrow C) of coupling (20).

    IMPORTANT Observe arrows on coupling (20).

    Fig 4: Identifying Input And Output Of Contact Cavity
    G07528526Courtesy of MERCEDES-BENZ USA
  7. Remove blue fuse (18) from coupling (19) of optical fiber wiring harness (17) from media interface.
  8. Remove optical fiber (17.1) from input contact cavity (arrow C) of optical fiber wiring harness coupling (19).

    IMPORTANT Observe arrows on coupling (19).

  9. Install optical fiber (17.1) into free contact cavity of coupling (20) of on-board optical fiber.
  10. Install blue fuse (18) in coupling (20) of on-board optical fiber.
  11. Remove optical fiber (17.2) from contact cavity (arrow D) of contact cavity (19) for optical fiber wiring harness from media interface.
  12. Install coupling (20) of on-board optical fiber in outer slot on black 34-pin coupling (21).
  13. Join the remaining optical fiber (22.1) and optical fiber (17.2) using connection piece (23).

    IMPORTANT The connection piece (23) is an adapter for closing the ring of the optical fiber again.

    The optical fiber (22.1) and the optical fiber (17.2) must audibly engage.

  14. Lock connection piece (23) by pressing it together.
    Fig 5: Identifying Optical Fiber, Optical Fiber, Wiring Harness And Connection Piece
    G07528527Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals