Retrofit rear entertainment control unit - AZ82.60-P-0015-01CWA

Bond felt tape onto video control unit (1).
The side of the video control unit (1) with the mounting brackets is not bonded.

Fig 1: Identifying Video Control Unit
Courtesy of MERCEDES-BENZ USA
Glue down video control unit (1) at lower cross strut (22) of seat frame with velcro strip (21).
The bonding areas must be free of dust and grease in order to prevent adhesion problems.

Fig 2: Identifying Video Control Unit On Lower Cross Strut Of Seat Frame With Velcro Strip
Courtesy of MERCEDES-BENZ USA

Only perform the following operation steps on vehicles with code (275) Memory package (driver seat, steering column, mirrors) or with code (242) Electrically adjustable front passenger seat with memory.
Bond felt tape onto rear entertainment control unit (2).
Do not bond the bottom of the rear entertainment control unit (2).

Fig 3: Identifying Rear Entertainment Control Unit
Courtesy of MERCEDES-BENZ USA
Fasten rear entertainment control unit (2) to upper cross strut (22) using velcro strip (21).
The bonding areas must be free of dust and grease in order to prevent adhesion problems.

Fig 4: Identifying Rear Entertainment Control Unit On Upper Cross Strut Using Velcro Strip
Courtesy of MERCEDES-BENZ USA