Retrofit docking station - AZ82.85-P-0004-01CW
Shown with installed glove box
- Unclip interior illumination from top of glove compartment and remove vehicle's own wiring harness.
- Insert docking station into released opening from inside and allow to engage into place. Fasten the docking station wiring harness (12) onto the glove compartment and route coupling (docking station to control unit) (13) into front passenger footwell.
- Connect vehicle's own wiring harness for the glove compartment illumination to the docking station (11). Connect interior lamp to branch-off line of the docking station and clip interior lamp from below into the docking station (11).
Do not damage the docking station wiring harness by crushing it or jamming it.
The coupling (docking station to control unit) (12) will be connected at a later stage to the control unit.