Measure front axle carrier (when removed) - AR40.30-P-0450P

MODEL 171 

Fig 1: Measuring Front Axle Carrier (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Measuring Front Axle Carrier (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Measure
1	Set up Celette straightening bench modular members	See set-up diagram for Celette straightening bench.
2	Install and secure checking fixtures, in the mounting bores of the Celette straightening bench	We recommend measuring the front axle carrier on the vehicle concerned before and after work on the straightening bench.
3	Place front axle carrier assembly (with front axle half) or as separate part (as shown) rotated through 180° onto the test fixture	The adjuster pins (arrows) on the modular member must be inserted into the reference bores in the front axle carrier.	BE40.30-P-1001-08A
4	Install in the reverse order

TEST VALUES FOR FRONT AXLE CARRIER

Number	Designation		Model 171
BE40.30-P-1001-08A	Maximum distance between contact surfaces of front axle carrier and checking fixture	mm	2.5