Removing and installing taillamp - AR82.10-P-4905V

MODEL 171.4 

Shown on the left taillamp (E3) 

Fig 1: Identifying Taillamp Components - Shown On Left Taillamp (E3)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove trim from rear end center assembly		AR68.30-P-4785V
2	Open service flap and frame (6) in side luggage compartment lining (3) until nuts (4) are accessible	Open the frame (6) carefully (arrow) If the frame (6) is damaged, the side trunk lining (3) must be replaced.
3	Separate electrical connector (5)
4	Unscrew nuts (4)
5	Remove left taillamp (E3) or right taillamp (E4)
6	Install in the reverse order