Cavity preservation following repair work - AR97.20-P-1500V

MODEL 171

Engine hood

Fig 1: Identifying Engine Hood Sealing Area

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Front Cross Member Sealing Area

Courtesy of MERCEDES-BENZ USA

Front cross member

Fig 3: Identifying Wheelhouse With Complete Left Front Longitudinal Member Sealing Area

Courtesy of MERCEDES-BENZ USA

Wheelhouse with complete left front longitudinal member

Fig 4: Identifying Left Inner A-Pillar Sealing Area

Courtesy of MERCEDES-BENZ USA

Left inner A-pillar

Left door

Fig 5: Identifying Left Door Sealing Area

Courtesy of MERCEDES-BENZ USA

Left outer side longitudinal member

Fig 6: Identifying Left Outer Side Longitudinal Member Sealing Area

Courtesy of MERCEDES-BENZ USA

Fig 7: Identifying Left Rear Wheelhouse Sealing Area

Courtesy of MERCEDES-BENZ USA

Left rear wheelhouse

Rear center section

Fig 8: Identifying Rear Center Section Sealing Area

Courtesy of MERCEDES-BENZ USA

Trunk lid

Fig 9: Identifying Trunk Lid Sealing Area

Courtesy of MERCEDES-BENZ USA

	Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when handling anticorrosion agents.	Never spray anticorrosion agents on flames or glowing hot objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection.	-
	Notes on cavity preservation	Model 124, 126, 129, 140, 168, 169, 170, 171, 201, 202, 203, 208, 209, 210, 211, 215, 220, 230, 240, 463, 639, 671, 690.6, 901, 902, 903, 904, 905 Model WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7	-
1	Perform repair preservation.	Apply cavity preservation agent from inside to shaded areas only after performing sealing work and paintwork, however, before assembly work. Perform repair preservation twice in sequence after a drying time of 5 minutes. The spraying hose should be stiff and the nozzles should spray at angle to the front and rear. The cavities should be dry. Move spraying into cavities as far as possible. Spray while slowly moving in and out.	-
	Processing instructions for cavity preservation agent		-
	Cavity protection, general		-
		Cavity preservation gun Sata HRS no. 11072	*WE58.40-Z-1006-08A
		MB cavity wax preservation, 1 l	*BR00.45-Z-1003-05A
2	Remove cavity preservation agent from drain holes	Processing temperature should not be below 15°C. Additional preservation measures may be required depending on the repair area deviating from the standard cavity preservation illustrated.	-

WORKSHOP EQUIPMENT

WE58.40-Z-1006-08A

Cavity preservation gun

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1003-05A	Preservation agent	A 000 986 72 70 05