Remove/install output flange - AR26.40-P-2475-03V

COLLARED NUT OUTPUT SHAFT TO MAIN SHAFT TIGHTENING TORQUE

Number	Designation		Transmission 711.65
BA26.10-P-1004-01F	Collared nut, output flange to main shaft	M26 Stage 1 Nm	200
		Stage 2	Releasing
		Stage 3 Nm	160

Remove output flange (1)

Counterhold output flange (1) with pin wrench (01).

Remove collar nut (2) from main shaft (3) using wrench socket (02) and connection piece (03).

Fig 1: Identifying Main Shaft And Collar Nut

Unfasten output flange (1) using puller (04) and remove.

Fig 2: Identifying Output Flange

Install output flange (1)

Inspect tapered seat of output flange (1) for traces of wear, corrosion and damage; install new output flange (1) if necessary.

Push output flange (1) onto main shaft (3).

Counterhold output flange (1) using) pin wrench (01) and tighten collar nut (2) using) socket wrench bit (02) and connection piece (03). Install new collar nut (2). Observe specified tightening torque.

Fig 3: Identifying Main Shaft And Collar Nut

Secure the collar nut (2). To do so, knock collar using a punch into the groove (arrow) of main shaft (3).

Fig 4: Locating Collar Nut

1. Output flange.

2. Collar nut.

3. Main shaft.