Remove/install electric power window on rear side window - AR67.39-P-4150V
MODEL 171
| Remove/Install | |||
|---|---|---|---|
| Risk of death cased by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | ||
| Risk of injury. Moving parts can pinch, crush or , in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating range of the mechanism when moving components. | ||
| 1 | Remove rear side window | AR67.30-P-4000V | |
| 2 | Remove wheelhouse cover (8) | ||
| 3 | Unscrew nut (7) | Installation: Align mounting screws for power window in center of oblong hole | |
| *BA67.39-P-1004-01A | |||
| 4 | Loosen locknut (11) for power windows on center console | *BA67.39-P-1002-01A | |
| 5 | Loosen mounting screw (2) for power window on center console | *BA67.39-P-1003-01A | |
| 6 | Remove power window (9) from center console upward | ||
| 7 | Disconnect connector from left rear power window motor (M10/5) or from right rear power window motor (M10/6) | ||
| 8 | Install in the reverse order | ||
| 9 | Adjust rear side windows | AR67.30-P-4200V |
SIDE WINDOWS ELECTRICAL SYSTEM
| Number | Designation | Model 171 | |
|---|---|---|---|
| BA67.39-P-1002-01A | Locknut, power window mount in center column | Nm | 8 |
| BA67.39-P-1003-01A | Bolt, power window mount in center console | Nm | 8 |
| BA67.39-P-1004-01A | Nut, power window mount in wheelhouse | Nm | 9 |