Disassemble/assemble rear bumper - AR88.20-P-2100V
MODEL 171.4 except CODE (220a) Parktronic System (PTS)
| Disassemble/assemble | |||
| 1 | Remove left impact damper (2) and right impact damper (2) from rear bumper paneling (1) | ||
| 2 | Remove spreading clips and remove left and right retaining strip (5) | ||
| 3 | Remove spreading clips (6) | ||
| 4 | Unclip frame (7) from rear bumper paneling (1) using mounting wedge and remove | Figure | |
| 5 | Take off gaskets (8) | ||
| 6 | Unclip threaded bolt (8) from frame (7) | ||
| 7 | Remove center impact damper (10) from rear bumper paneling (1) | ||
| 8 | Remove towing device cover (11) from rear bumper paneling (1) | ||
| 9.1 | Heat up right and left dirt deflector (12) with hot air gun and detach from rear bumper paneling (1) with mounting wedge | Not when replacing rear bumper paneling (1). | |
Replace left and right dirt deflector (12). |
|||
| 10 | Assemble in reverse order |