Remove/install ATA alarm signal siren - AR80.50-P-9840V
MODEL 171.4 with CODE (551a) Anti-theft alarm system (ATA)
| Removal/installation | |||
|---|---|---|---|
| 1 | Open engine hood and raise to vertical position | AR88.40-P-1000V | |
| 2 | Loosen bolts (1) on battery cover (2) and remove battery cover (2) | ||
| 3 | Unscrew nuts (3) | *BA80.50-P-1004-01A | |
| 4 | Remove alarm signal siren with additional battery (H3/1) with bracket (4) and move upward until electrical connectors (5) are accessible | ||
| 5 | Disconnect electrical connector (5) | ||
| 6.1 | Unscrew screw (6) and remove alarm signal siren with additional battery (H3/1) from bracket (4) | When replacing alarm signal siren with additional battery (H3/1). | |
| *BA80.50-P-1003-01A | |||
| 7 | Install in the reverse order |
ANTI-THEFT ALARM SYSTEM
| Number | Designation | Model 171 | |
|---|---|---|---|
| BA80.50-P-1003-01A | Bolt for alarm signal siren with additional battery on bracket | Nm | 14 |
| BA80.50-P-1004-01A | Nut for mount on alarm signal siren with additional battery on firewall stud | Nm | 6 |