LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> SL600 >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seats, Restraints & Roll Bar Systems -- Trouble Diagnosis -- 230 Chassis >> Trouble Diagnosis >> Fault codes B1863 and/or B1864 stored in restraint systems control unit - AF91.40-P-8000A >> Replace connector - AF91.40-P-8000-01A

Replace connector - AF91.40-P-8000-01A

REFER TO TESTING & REPAIR Repairing wiring harness using solder connectors   AR00.19-P-0100-09A
Fig 1: Identifying Wiring Harness Repair Kit (220 589 01 99 00)
G05076907
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1004-20A Hot-air gun

IMPORTANT Frame floor system:

  1. Carefully remove textile tape in area of connector.
  2. Cut off cable directly at connector housing.
  3. Remove approx. 15 mm of insulation from electrical leads.

    NOTES Do not strip insulation of the plastic-sheathed cable

  4. Slide on solder connector.
  5. Twist strands of two cable ends together.
  6. Position solder connector in center and shrink (solder) with hot air blower.
  7. Wrap textile tape around lead from connector up to over solder connector.
  8. Slide new connector housing over gray clip part.
scientia non olet · About LEMON Manuals