LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> SL600 >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Body Electrical -- Basic Knowledge - 230 Chassis - 1 Of 2 >> Basic Knowledge >> Switch entry/exit lamps on/off, function - GF82.20-P-2022R

Switch entry/exit lamps on/off, function - GF82.20-P-2022R

MODEL 230 

Fig 1: Switch Entry/Exit Lamps On/Off Function - Communication Diagram
G05075574

Networking 

An entry/exit lamp is located at the bottom edge of each door.

Function requirements: 

IMPORTANTIn general only entry/exit lamps of opened doors are actuated! 

Switching entry/exit lamps on: 

Switching entry/exit lamps off: 

Switching on again after automatic switch-off 

The on period is extended or started once again if:

Actuation 

The entry/exit lamps are actuated by the relevant door control module (N69/1, N69/2).

The door control modules require the following CAN messages for this purpose:

  Exterior light-dependent control of the interior lights, function   GF82.20-P-3003R 
  Overhead control panel control module, location/purpose/design/function   GF82.20-P-4101R 
  Rear SAM control module with fuse and relay module position/task/design   GF54.21-P-4112R
  Driver door control module location/task/ design   GF72.29-P-4113R
  Passenger door control module location/task/ design   GF72.29-P-4114R