Remove/install front axle level sensors - AR82.10-P-0004R

MODEL 230.4 

Shown on model 230.4 with CODE (487) Active Body Control (ABC) 

Fig 1: Identifying Front Axle Level Sensors Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with vehicle lift		Fig 2
2	Disconnect electrical connector from left front level sensor (B22/8) of from right front level sensor (B22/9)
3	Unscrew nut (1) from transverse control arm (6)		*BA82.10-P-1001-01A
4	Undo nuts (2) from body and remove left front level sensor (B22/8) or right front level sensor (B22/9)
5	Install in the reverse order
6	Calibrate vehicle level (level calibration)	After replacing the left front level sensor (B22/8) or right front level sensor (B22/9).
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		STAR DIAGNOSIS system	*WH58.30-Z-1048-13A

Fig 2: Identifying Adapter Kit (230 589 00 31 00)

Courtesy of MERCEDES-BENZ USA