LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> SL55 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Air Intake, Turbo Charging - 230 Chassis >> Testing & Repair >> Removing and installing the circulation pump for the low temperature water circuit - AR09.41-P-6925R (SL600, SL65 AMG)

Removing and installing the circulation pump for the low temperature water circuit - AR09.41-P-6925R (SL600, SL65 AMG)

ENGINE 275 in MODEL 230 

Fig 1: Identifying Pneumatic Hose, Electrical Connector, Coolant Hose And Bracket
G05068053Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install    
NOTES Risk of death  caused by vehicle slipping or toppling off the lifting platform. Align vehicle between the columns of the lifting platform and position the four support plates below the lifting platform support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
DANGER Risk of injury  to skin and eyes caused by scalding from contact with hot coolant spray.
Risk of poisoning  from swallowing coolant.
Do not open cooling system unless coolant temperature is below 90deg;C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.
AS20.00-Z-0001-01A
DANGER Risk of injury  caused by fingers being jammed or pinched  when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. When moving components, ensure that no body parts or limbs are within the operating range of moving parts. AS00.00-Z-0011-01A
1 Open engine hood   AR88.40-P-1000R
2 Remove lower engine compartment paneling   AR61.20-P-1105R
3 Detach front bumper   AR88.20-P-2000R
4 Drain the coolant out of the low temperature water circuit   AR20.00-P-1142HM
NOTES Notes on coolant   AH20.00-N-2080-01A
5 Remove coolant hoses (5, 6) on the circulation pump for the charge air cooler (M44)    
6 Unscrew bolt (3) and loosen the clamp (4) TORQUE SPECIFICATION *BA09.41-P-1003-01G 
7 Detach pneumatic hose (1) at charge air cooler circulation pump (M44)    
8 Pull off the electrical plug connector (2) on the circulation pump for the charge air cooler (M44)    
9 Remove the circulation pump for the charge air cooler (M44) TORQUE SPECIFICATION *BA09.41-P-1004-01G 
10 Install in the reverse order    
11 Venting air from the low temperature circuit   AR20.00-P-1145H
12 Inspect cooling system for leaks   AR20.00-P-1010HN
CHARGE AIR PIPE/CHARGE AIR COOLING

Number Designation Engines 275, 285
BA09.41-P-1003-01G Bolt, pump for low temperature water circuit to bracket Nm 5
BA09.41-P-1004-01G Hose clamps at pump for low temperature water circuit Nm 3