Rear Wall & Rear End - GEN'L Info - S-Class (221)

• General Information
  • General notes: Passenger cars: Rear wall and rear end - AH64.00-Z-9999AZ
• Testing & Repair
  • Testing and repair work: Passenger cars: Rear wall and rear end - AR64.00-Z-9221AA
  • Remove/install rear shelf reinforcement - AR64.10-P-1200SX
  • Cut off rear end center assembly - AR64.20-P-1000-02SX
  • Prepare bottom rear center section for installation - AR64.20-P-1000-07SX
  • Install and weld in bottom rear center section - AR64.20-P-1000-08SX
  • Replace complete bottom rear center section - AR64.20-P-1000SX
  • Separate rear center section with crossmember - AR64.20-P-1060-01SX
  • Install crossmember and weld in - AR64.20-P-1060-03SX
  • Replace bottom rear center section together with rear crossmember - AR64.20-P-1060SX
  • Prepare rear crossmember for installation. - AR64.20-P-1100-02SX
  • Remove longitudinal member at rear - AR64.20-P-1200-22SX
  • Prepare rear longitudinal member for installation - AR64.20-P-1200-23SX
  • Install rear longitudinal member - AR64.20-P-1200-24SX
  • Left side rear end damage - AR64.20-P-1200SX
  • Completely rear longitudinal member - AR64.20-P-1220SX
  • Prepare locking lug on rear longitudinal member - AR64.20-P-1240-02SX
  • Install locking lug on rear longitudinal member - AR64.20-P-1240-03SX
  • Partially remove rear longitudinal member - AR64.20-P-1260-01SX
  • Partially prepare rear longitudinal member - AR64.20-P-1260-02SX
  • Partially install rear longitudinal member - AR64.20-P-1260-03SX
• Torque Specifications
  • Tightening torques: Passenger cars: Rear wall and rear end - BA64.00-Z-9999AZ
  • Rear panel - BA64.10-P-1000-01A
• Special Tools
  • 201 589 00 27 00 Cross-brace - WS64.00-P-0012K
  • Special tools: Passenger cars: Rear wall and rear end - WS64.00-Z-9999AZ