Remove/install rear seat cushion - AR91.12-P-1020SXS
MODEL 221.1 with CODE (Z07) Top protection
Shown on right rear seat cushion
| Remove/install | |||
| 1 | Move left or right rear seat cushion (1) approx. 50 mm out of the rearmost position to the front and set cushion angle to the lowest position | ||
| 2 | Switch off the ignition and remove the transmitter key from the EIS control unit | ||
| 3 | Push springs for seat locking mechanism (2) underneath the rear seat cushion (1) outwards and lift rear seat cushion (1) | ||
| 4 | Unclip electrical lines from bracket (3) | ||
| 5 | Disconnect left rear heated seats connector (X54/23) or right rear heated seats connector (X54/24) | ||
| 6 | Detach left rear seat ventilation connector (X55/25) or right rear seat ventilation connector (X55/26) | ||
| 7 | Detach two piece connector housing (4) using suitable screwdriver | ||
| 8 | Remove rear seat cushion (1) from vehicle | ||
| 9 | Install in the reverse order |