Line up rear window in the body opening - AR67.20-P-2000-04SX

MODIFICATION NOTES

11.5.06

Distance between upper edge of shaped rubber gasket and rear edge of roof

Model 221

*BE67.20-P-1001-01K

CHECK VALUES FOR REAR WALL WINDOW, REAR WINDOW

Number	Designation			Model 216	Model 221
BE67.20-P-1001-01K	Distance between upper edge of shaped rubber gasket and rear edge of roof	Dimension "A"	mm	5 (±0.5)	5 (±0.5)
		See picture		-	-

Fig 1: Identifying Feeler Gauge (129 589 03 21 00)

Courtesy of MERCEDES-BENZ USA

1. Install rear-end window (1) on body flange with aid of helper, align between upper edge of shaped rubber gasket and rear edge of roof (A) and center at side. Cup suction tool, see GOTIS http://gotis.aftersales.mercedes-benz.com
   Fig 2: Identifying Distance Between Upper Edge Of Shaped Rubber Gasket & Rear Edge Of Roof

   Courtesy of MERCEDES-BENZ USA
2. Attach suitable strips of adhesive tape (arrows) and cut at upper edge of shaped rubber gasket on rear-end window (1).
3. Remove rear-end window (1) from body flange with aid of helper.

Fig 3: Locating Strips Of Adhesive Tape

Courtesy of MERCEDES-BENZ USA