Guidelines for removing fuel tank when performing welding work on bodies - AH60.00-P-3000-01Z
All models
When a repair or partial rebuilding of the listed parts is being carried out, a supervisor must decide whether to remove the fuel tank depending on the nature and extent of the damage in each individual case.
In vehicles with a fuel evaporation control system, the system must be covered with a welding protection blanket or removed when welding work is being carried out near the incoming vent pipe or activated charcoal canister.
REPLACE -
| Rear fender, left (petrol models only) | Rear fender, right | Rear fender front section, complete | Main floor (3) | Rear center piece, bottom section | Rear floor | Spare wheel recess | Rear longitudinal member | B-pillar | C-pillar, outer section | Longitudinal member on outside | |||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| W 114/115 | (1) | (1) | - | (1) | (1) | (1) | (1) | (1) | - | - | - | ||
| R 107/ W 116 | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| W 123 | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| S 123 | (1) | (1) | - | (1) | (1) | (1) | (1) | (1) | - | - | - | ||
| W/C 126 | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| Offroad veh. 460/61 | (1) | (1) | - | - | (1) | (1) | - | (1) | - | (1) | - | ||
| 201 W | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| W / C 124 | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| 124 s | (1) | (1) | - | (1) | (1) | (1) | (1) | (1) | - | - | - | ||
| Offroad veh. 463 | (1) | (1) | - | - | (1) | (1) | - | (1) | - | (1) | - | ||
| R 129 | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | - | - | ||
| W / C 140 | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| 202 W | - | (4) | (1) | (1) | - | (1) | - | (1) | - | - | (1) | ||
| 202 s | - | (4) | (1) | (1) | - | (1) | - | (1) | - | - | (1) | ||
| 210 W | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| 210 s | (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | (1) | - | ||
| (1) | (1) | - | (1) | - | (1) | (1) | (1) | - | - | - | |||
| C 208 | (2)1 | (2)1 | - | (1) | - | (1) | - | (1) | - | - | (1) | ||
| A 208 | - | (4) | - | (1) | - | (1) | - | (1) | (1) | - | (1) | ||
| W168 | - | (1) | - | (1) | - | (1) | - | (1) | - | - | - | ||
| W220 | (1) | (1) | - | (1) | - | (1) | - | (1) | - | (1) | - | ||
| C215 | - | - | - | (1) | - | (1) | - | (1) | - | - | - | ||
| W 203 | - | (4) | (1) | (1) | - | (1) | - | (1) | - | - | (1) | ||
| CL 203 | - | (4) | (1) | (1) | - | (1) | - | (1) | - | - | (1) | ||
| 203 s | - | (4) | (1) | (1) | - | (1) | - | (1) | - | - | (1) | ||
| - | (1) | - | - | - | (1) | (1) | (1) | (1) | - | - | |||
| 414 C | - | (1) | - | (1) | - | (1) | - | (1) | - | - | - | ||
| 211 W | - | (4) | (1) | (1) | - | (1) | - | (1) | - | (4) | - | ||
| A/C 209.3 | - | - | - | (1) | - | (1) | - | (1) | - | (1) | - | ||
| 240 W | - | (1) | - | (1) | - | (1) | - | (1) | - | (1) | - | ||
If the damage is more extensive and welding work is required at the wheel arch panel or C-pillar, the fuel tank must also be removed in diesel vehicles. |
|||||||||||||
|
|||||||||||||
|
|||||||||||||
Seal airtight with the |
|||||||||||||