Remove/install front floor covering (left) - AR68.20-P-2050RT

MODEL 251 

Fig 1: Identifying Left Front Floor Covering Remove/Install Component (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Left Front Floor Covering Remove/Install Component (2 Of 2)

Courtesy of MERCEDES-BENZ USA

Front seat removed for better illustration 

	Remove/Install
1	Completely move left front seat toward rear	See Operator's Manual
2	Remove door sill molding		AR68.30-P-4100RT
3	Remove paneling in footwell		AR68.30-P-4010RT
4	Unscrew nuts (3), remove accelerator pedal (4) and lay down in footwell	Slightly pull accelerator pedal (4) out in upper area, press upward (arrow D) and remove from firewall. Do not separate electrical connector	AR30.12-P-1321RT
5	Unclip guide rail cover (1) and remove from guide rail at side (arrow A).	Long wedge	Figure
6	Unclip guide rail cover (2) and remove from guide rail toward front (arrow C).	To unclip, guide suitable tool into opening in guide rail cover (2) (arrow B) and unclip guide rail cover (2).
7	Pull out floor covering (5) below center console (6) (arrows E)	Long wedge	Figure
8	Raise floor covering (5) on front seat (arrow F) and pull out of footwell (arrow G) toward rear.	Ensure that floor covering is seated correctly below center console and in brackets (7).
9	Remove floor covering (5)
10	Install in the reverse order

Fig 3: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA