Remove/install headlamp cleaning system pump - AR82.35-P-6003RT

MODELS 251 with CODE (600) Headlamp cleaning system 

Fig 1: Identifying Headlamp Cleaning System Pump Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove front section of fender liner in front fender	Front section of fender liner in right front fender Wheel does not need to be removed.	AR88.10-P-1310RT
2	Compress safety clamp (2) and detach washer fluid hose (3) from the HCS pump (M5/2)	Collect escaping washer fluid with a suitable reservoir.
3	Remove HCS pump (M5/2) upward (arrow) out of the washer fluid reservoir (1), seal off washer fluid reservoir (1) using stop plug (4)	Collect escaping washer fluid with a suitable reservoir. Check seal (5), replace if necessary. Note correct installation position.
		Mounting wedge	Figure
		Set of plugs	Figure
4	Disconnect electrical connector (6) and remove HCS pump (M5/2)
5	Install in the reverse order
6	Fill washer fluid reservoir (1)
	Check windshield washing unit fluid level, top up if necessary		AP82.35-P-8210RT
7	Carry out function check of the windshield wipers and the windshield washer system

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Set Of Plugs (129 589 00 91 00)

Courtesy of MERCEDES-BENZ USA