Set up Celette straightening bench - AR60.10-P-1060RT

MODEL 251.0/1 

Fig 1: Identifying Celette Straightening Bench

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

16.1.08

Special tool 251 589 24 23 00 added

Step 9

	Installation, removal
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Lift vehicle with two-post lift
2	Set-up Celette straightening bench (1)
3	Install Celette module members	Model 251.0	AR60.10-P-1060-01RT
		Model 251.1	AR60.10-P-1060-01RTA
4	Install Celette straightening tool and multi-Z-elements	Model 251.0	AR60.10-P-1060-02RT
		Model 251.1	AR60.10-P-1060-02RTA
5	Remove stop plugs from jack support points
6	Set vehicle onto straightening bench
7	Align vehicle on straightening bench	Observe check bores!
8	Fasten vehicle to straightening bench
9	Install side portal with portal straightening set	Only when required for repair to vehicle.
		Model 251.0	AR60.20-P-1550-01RT
		Portal frame	Fig 2
		Inspection and welding device	Fig 3
		Inspection and welding device	Fig 4
		Model 251.1	AR60.20-P-1550-01RTA
		Portal frame	Fig 2
		Inspection and welding device	Fig 3
10	Detach in the reverse order

Fig 2: Identifying Portal Frame (129 589 03 23 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Inspection And Welding Device (251 589 00 23 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Inspection And Welding Device (251 589 24 23 00)

Courtesy of MERCEDES-BENZ USA