Replace center floor - AR64.20-P-1070RT
MODEL 251
| Removing | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. | AS00.00-Z-0017-01A | |
| General information on body repair | All models | AH60.00-N-0001-01A | |
| 1 | Remove detachable parts in the repair area | ||
| 2 | Cover all detachable body components remaining in vehicle (area to be repaired) | ||
| 3 | Remove center floor | AR64.20-P-1070-01RT | |
Vario Drill WS 91 spot weld removing tool Round wire brush, braided, 70 mm Drill |
Figure | ||
| 4 | Prepare mating surfaces on vehicle for center floor | AR64.20-P-1070-02RT | |
| Round wire brush, braided, 70 mm Drill Wet/dry vacuum cleaner |
|||
| Zinc dust paint suitable for spot welding | *BR00.45-Z-1001-07A | ||
| Install | |||
| 5 | Install center floor | Clamping pliers Manual temporary fastener, dia. 6.4 mm - clamping range 0 - 15 mm, identification color silver Blind rivet/punch riveting method Drill Wet/dry vacuum cleaner |
AR64.20-P-1070-03RT |
| Rivet | *BR00.45-Z-1001-13A | ||
| 6 | Clean repair areas | ||
| 7 | Prime repair area using primer filler | ||
| 8 | Supplement standard seam sealing | ||
| 9 | Paint repair areas and adjacent surfaces | ||
| 10 | Apply additional cavity preservation | ||
| 11 | Reinstall all detachable parts removed |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1001-07A | Zinc dust paint suitable for spot welding | A 000 986 34 42 |
| BR00.45-Z-1001-13A | Blind rivet 6.4 14 | A 003 990 35 97 |