Remove/install front floor covering (right) - AR68.20-P-2070RT

MODEL 251 

Fig 1: Identifying Right Front Floor Covering Remove/Install Component (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Right Front Floor Covering Remove/Install Component (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Completely move right front seat toward rear	See Operator's Manual
2	Remove door sill molding		AR68.30-P-4100RT
3	Remove paneling in footwell		AR68.30-P-4010RT
4	Unclip guide rail cover (1) and remove from guide rail toward front (arrow A).	To unclip, guide suitable tool into opening in guide rail cover (1) (arrow B) and unclip guide rail cover (1).
5	Unclip guide rail cover (2) and remove from guide rail at side (arrow C).	Long wedge	Figure
6	Pull floor covering (3) out below center console (4) (arrows D)	Long wedge	Figure
7	Pull out floor covering (3) between front seat and center console below center console (arrows E) and pivot toward front.
8	Raise floor covering (3) on front seat (arrow F) and pull out of footwell (arrow G) toward rear.	Ensure that front floor covering (3) is seated correctly below center console
9	Remove floor covering (3)
10	Install in the reverse order

Fig 3: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA