LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> ML63 >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Door Sill, DVD Player & IPOD Interface -- Retrofitting & Conversion -- 164 Chassis >> Retrofitting & Conversion >> Retrofit D-net portable CTEL - AZ82.70-P-0001GZ >> Retrofit wiring harness. - AZ82.70-P-0001-04GZB

Retrofit wiring harness. - AZ82.70-P-0001-04GZB

Fig 1: Identifying Module, White Connector, DVD Player Wiring Harness And Blue Connector
G05260526Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  1. Connect black, slanted plug (29) from DVD player wiring harness (30) to DVD player (18).
  2. Connect modules (26, 27) to DVD player brackets (18) with one of the provided sheet metal screws each.
    Fig 2: Identifying Modules, DVD Player Brackets, DVD Player Wiring Harness And DVD Player
    G05260527Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  3. Route white, 3-pin DVD player wiring harness connector (30) between body panels (see arrow) into spare tire well, as per picture.
    Fig 3: Identifying DVD Player Bracket And 3-Pin DVD Player Wiring Harness Connector
    G05260528Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  4. Lift paneling in spare tire well along right vehicle longitudinal member high enough that the DVD player wiring harness (30) can be routed.
  5. Fasten DVD player wiring harness (30) in spare tire well with felt tape (34).
  6. Continue to route DVD player wiring harness (30) along vehicle's own wiring harness (35) to load compartment fuse and relay box (F4) and fasten with tie straps.
    Fig 4: Identifying DVD Player Wiring Harness, White Connector, Load Compartment Fuse And Relay Box
    G05260529Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  7. Connect white connector (14) from retrofitted accessory wiring harness to white connector (28) on DVD player wiring harness (30).
  8. Tie back excess on DVD player wiring harness (30) on present lines with tie strap.
  9. Remove anchoring lug from floor covering (see arrow).
  10. Remove rear cover above left seat rail for right front seat (see magnified drawing).
  11. Route screen wiring harness (32) between floor covering and floor panel to DVD player (18) as shown in figure.
  12. Connect black connector (33) from screen wiring harness (32) to DVD player (18).

    IMPORTANT Plug black connector (33) into connector for "Monitor 1" or "Monitor 2".

    Fig 5: Identifying Screen Wiring Harness, Black Connector And DVD Player
    G05260530Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  13. Tie back excessive monitor wiring harness (32) with tie straps so that it does not chafe or make noises.