Remove/install ashtray housing from front center console - AR68.20-P-2400GZ

MODEL 164 

Fig 1: Identifying Ashtray Housing And Paneling

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Ashtray Housing And Screws

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Ashtray Housing And Electrical Connector

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal/installation
1	Switch off ignition and remove transmitter key from EIS control unit	On vehicles with keyless go, code 889: Press keyless go start/stop button repeatedly until the ignition is switched off. Remove transmitter key from vehicle and store outside transmitter range (at least 2 m).
2	Open ashtray housing (1)
3	Lift paneling (2) (arrows))
4	Close ashtray housing (1)
5	Remove screws (3)
6	Slide ashtray housing (1) toward rear
7	Turn ashtray housing (1) and disconnect electrical connector (4)
8	Remove ashtray housing (1)
9	Install in the reverse order