Bolt tightening procedure for cylinder head cover - AR01.20-P-5014-03PI
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mercedes-Benz ML350, 2010 Mercedes-Benz ML350, 2009 Mercedes-Benz ML320, 2009 Mercedes-Benz GL320, and 2008 Mercedes-Benz ML320. However, it is still accessible from the selected car via links, so may be relevant.
MODIFICATION NOTES
| 9.4.10 | Value changed: bolt, cylinder head cover on cylinder head | *BA01.20-P-1001-01P |
CRANKCASE VENTILATION, CYLINDER HEAD COVER
| Number | Designation | Engine 642 | ||
|---|---|---|---|---|
| BA01.20-P-1001-01P | Bolt, cylinder head cover to cylinder head | Stage 1, apply | Nm | 4 |
| Stage 2, initial torque | Nm | 6 | ||
| Stage 3, final torque | Nm | 9 | ||
Tightening of the bolts must take place according to the specified sequence in the scheme.
Loosen bolts in reverse order.
The bolts should be tightened any further after the cold test.
The right hand cylinder head cover
Tighten cylinder head cover bolts in the numerical sequence.
- Tighten bolts 8 and 11 to Stage 1.
- Tighten bolts (1 - 30) to Stage 2.
- Tighten bolts (1 - -30) to Stage 3.
Left cylinder head cover
Tighten cylinder head cover bolts in the numerical sequence.
- Tighten bolts 8 and 11 to Stage 1.
- Tighten bolts (1 - -28) to Stage 2.
- Tighten bolts (1 - -28) to Stage 3.