LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> GL450 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Rear Wall & Rear End >> Testing & Repair >> Replace complete bottom rear center section - AR64.20-P-1000 >> Replace complete bottom rear center section - AR64.20-P-1000GY >> Install and weld in outer rear center section - AR64.20-P-1000-10GY

Install and weld in outer rear center section - AR64.20-P-1000-10GY

NOTES Measures for preventing damage to vehicles or components when performing electric welding work All models AH00.00-N-0005-01A
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1003-02A Clamping pliers
WH58.30-Z-1001-03A Round wire brush, braided, dia. 70 mm
WORKSHOP EQUIPMENT

WE58.40-Z-1002-02A Spot welder
WE58.40-Z-1001-03A Drill (electric/pneumatic)
WE58.40-Z-1005-03A Wet/dry vacuum cleaner
  1. Fit outer rear center section and fasten with clamping pliers COMMERCIALLY AVAILABLE TOOLS .

    IMPORTANT If applicable, realign outer rear center section in relation to adjacent surfaces.

  2. POLARIZATION RESISTANCE SINGLE-ROW SPOT WELD outer rear center section in areas A and B.
  3. Clean weld joints.
    Fig 1: Identifying Weld In Outer Rear Center Section Shaded Areas A And B
    G05259370Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals