Remove/install antenna splitter - AR82.70-P-8953GZ

MODEL 164 with CODE (359) TELE AID emergency call system 

Only in combination with a navigation system 

Shown on model 164.1 with USA version, code 494 

Fig 1: Identifying Antenna Splitter Components Location

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Release rear seat (1) and fold forward
2	Raise cover (2)
3	Disconnect antenna cable connector (3) from GPS antenna splitter (A2/5)	Press together locking tabs of antenna cable connector in lower  section (arrows A) and detach antenna cable connector from GPS antenna splitter (A2/5). Installation:  Pay attention to correct latching of the locking tabs.
4	Detach GPS antenna splitter (A2/5) upwards from bracket	Do not damage clip (4).
		Long wedge	Figure
5	Disconnect antenna cable connector (5, 6) from GPS antenna splitter (A2/5) and remove GPS antenna splitter (A2/5)	Press together locking tabs of antenna cable connectors in upper  section (arrows B and C) and detach antenna cable connectors from GPS antenna splitter (A2/5). Installation:  Pay attention to correct latching of the locking tabs.
6	Install in the reverse order

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.