Retrofit iPod interface wiring harness - AZ82.60-P-0001-01GZ

Installation illustrated with COMAND operating, display and control unit (A40/3) 

The interface connector (7) can be connected to the iPod interface later.

Fig 1: Identifying Radio Adapter Plug, Radio Adapter Connector, Interface Coupling And Interface Wiring Harness

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

1. Remove MOST connector (22) from standard radio connector and install in radio adapter connector (14) on interface wiring harness.

   Risk of breakage!  Do not kink optical waveguide, route over sharp edges or bend in radii smaller than 25 mm. Tensile forces on inserts must not exceed 65 N. Do not squeeze fiber optical cable and do not compress with clamps or tie straps.

   Fig 2: Identifying MOST Connector And Radio Adapter Connector

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
2. Connect standard radio connector (13) to radio adapter plug (12) on interface wiring harness.
3. Connect radio adapter connector (14) on interface wiring harness to COMAND operating, display and control unit (A40/3).
   Fig 3: Identifying Standard Radio Connector, Radio Adapter Plug And Radio Adapter Connector

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.