Remove/install lamp unit - AR82.10-P-4730GZ
MODEL 164
Shown on model 164.1
| Remove/install | |||
|---|---|---|---|
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard through highly flammable material in the area of damaged xenon bulbs. Risk of injury through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst. Risk of poisoning through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds. |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated. | AS82.10-Z-0001-01A | |
| 1 | Switch off ignition and remove transmitter key from EIS control unit | Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). |
|
| 2 | Remove front bumper | AR88.20-P-2000GZ | |
| 3 | Remove bolts (1) | ||
| 4 | Remove left front lamp unit (E1) or right front lamp unit (E2) and disconnect electrical connector (2) | ||
| 5 | Install in the reverse order | ||
| Checking | |||
| 6 | Adjust the zero position of the xenon headlamps | TAR DIAGNOSIS diagnosis system | *WH58.30-Z-1048-13A |
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 7 | Check the setting of the xenon headlamps and adjust if necessary |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1048-13A | STAR DIAGNOSIS Compact diagnosis system for passenger cars | 6511 1801 00 |