Deployment of emergency tensioning retractor units when no deployment device is present - AR91.40-P-0611-05A

	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. Interrupt the current supply when working on these units. Model 163, 168, 170, 202 as of 1.7.93, 203, 208, 209, 210, 215, 220, 230, 414, 463	AS91.00-Z-0001-01A
	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag units with deployment side facing upwards, do not subject to temperatures above 100 °C. When working on these units interrupt the current supply and detach airbag (AB) with emergency tensioning retractor test connector/connector (X11/13) Model 202 up to 30.6.93	AS91.00-Z-0001-01B
	Notes on controlled deployment of airbag, sidebag and emergency tensioning retractor units	For model 163, 168, 170, 202, 203, 209, 208, 210, 215, 220, 230, 414, 463, not valid for	AH91.60-P-0611-02P
	Ignition cable for firing airbag and seat belt tensioner units		WF58.50-P-9160-02A
	Notes on disposing of airbag and emergency tensioning retractor units	All models	OS91.00-P-0001-01A

Use of self-fabricated ignition cable 

1. Fabricate ignition cable with a length of 10 m with pressure switch.
2. Plug the 2-pin plug coupling into the corresponding emergency tensioning retractor unit.
3. Connect ignition cable to battery.
4. Press both pressure switches at the same time.

   Keep a distance of 10 m for safety.