Remove/install SCR frame module control unit - AR14.40-P-2020GY
ENGINES 642.886 in MODEL 463
| Remove/install | |||
|---|---|---|---|
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Switch off ignition | ||
| 2 | Fold back LH floor carpet in the luggage compartment | ||
| 3 | Detach cover | ||
| 4 | Release and detach electrical connection on AdBlue® control unit (N118/5) | ||
| 5 | Unscrew nuts and remove AdBlue® control unit (N118/5) | ||
| 6 | Install in the reverse order | ||
| 7 | Fill AdBlue® tank. | After installing the new AdBlue® control unit (N118/5) BLUETEC AdBlue® filling pumps |
AR14.40-P-2014-02G |
| *BF14.40-P-1001-01A | |||
| 8 | Attach STAR DIAGNOSIS, write fill level of the AdBlue® tank into the AdBlue® control unit (N118/5) using STAR DIAGNOSIS. | After installing the new AdBlue® control unit (N118/5) | AD00.00-P-2000-04A |
FILLING CAPACITY FOR BLUETEC DIESEL EXHAUST TREATMENT (SCR)
| Number | Designation | Engine 642 in model 463 | ||
|---|---|---|---|---|
| BF14.40-P-1001-01A | AdBlue tank | Filling capacity for the initial filling | Liters | 16.0 |
| Filling capacity for a service filling | Liters | 15.0 | ||
| Specifications for service products | Sheet | BB00.40-P-0352-01A |