Remove/install turn signal lamps - AR82.10-P-4725G

MODEL 461 

MODEL 463.200 /202 /204 /206 /207 /208 /209 /220 /221 /222 /224 /225 /227 /228 /230 /231 /232 /233 /236 /237 /240 /241 /243 /244 /245 /246 /247 /248 /249 /250 /254 /270 /271 /300 /303 /304 /306 /307 /308 /309 /320 /321 /322 /323 /324 /325 /327 /328 /330 /331 /332 /333 /336 /340 /341 /346 

Shown on models 463.243/246 AMG 

Fig 1: Identifying Grating

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Lens

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Electrical Connectors, Lamp Carrier And Base

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove wheel well cover	Not all models are equipped with wheel well liners.
2	Remove grille (A)	If installed.
3	Detach turn signal lamp lens (1)
4	Detach electrical connectors (2, 3)	Insulate electrical connectors (2, 3) to prevent against unintentional contact, otherwise this may lead to a short-circuit.
5	Detach lamp carrier (4) with base (5)
6	Install in the reverse order
7	Perform function test