Legend of wiring diagram of backup assist (BA) - PE54.65-P-2100-60A
MODEL 463 with CODE (J44) Ultrasonic backup assist
| Item | Designation | Coordinate |
|---|---|---|
| A43 | PTS sensor assembly (rear bumper) | 32K |
| 33K | ||
| 35K | ||
| 36K | ||
| A44/1 | BA [RFH] warning display | 3A |
| A44/1x1 | BA [RFH] connector | 2D |
| E7 | Reverse lamp | 10K |
| F1 | Fuse box | 17H |
| K26 | Wiper system relay module | 16H |
| M6/1 | Wiper motor | 15K |
| N62 | BA [RFH] control module | 7A |
| 17A | ||
| 25A | ||
| 35A | ||
| R2/3 | Right heated windshield washer nozzle | 21H |
| R31 | Version coding resistor (1000 ohms) | 26L |
| S2/1 | Ignition/starter switch | 18F |
| S4x1 | Combination switch connector | 15H |
| S9/1 | Stop lamp switch (4-pin) | 19H |
| S16/10 | Transmission range recognition switch (voltage coded) | 12J |
| 19H | ||
| U13 | Valid for right-hand steering | 14H |
| 20H | ||
| U54 | Valid for towing hitch | 22F |
| U190 | Valid for engine APS | 11L |
| W30 | Ground (frame) | 10L |
| 11L | ||
| 23G | ||
| X12/3 | Terminal block (circuit 30, 15, 61 (3-pin) | 17F |
| X24/5 | APS/HLS connector | 11K |
| X26/26 | BA [RFH] connector | 9D |
| 25D | ||
| X26/27 | Rear bumper sensors connector | 30F |
| X35/27 | BA [RFH] warning element intermediate connector | 2G |
| X58 | Trailer hitch socket (13-pin) | 23K |
| X60/3 | High/low tone setting connector | 28F |
| X92/3 | Frame connector (22-pin) | 12E |
| Z36/1 | Ground connector sleeve (rear PTS sensors) | 38H |
| Z36/2 | Voltage supply connector sleeve (rear PTS sensors) | 37G |
| Z50/1 | Connector sleeve 1 | 20H |