Adjust height at rear of titling/sliding roof - AR77.20-P-1100-04A
| Centering bolts for sliding roof | WF58.50-P-7720-01A |
TEST VALUES FOR TILTING/SLIDING ROOF
| Number | Designation | MODEL 463 | ||
|---|---|---|---|---|
| BE77.20-P-1001-01B | Height setting | Front: deeper than outer skin of roof | mm | 0 to 1 |
| Rear: higher than outer skin of roof | mm | 0 to 1 | ||
- Close titling/sliding roof.
- Loosen screws (arrows) from retaining brackets (1) on left and right.
- Insert left and right centering bolts (3) into centering holes.
- Adjust titling/sliding roof cover in relation to outer surface of roof.
Adjust edges on rear radiuses of tilting/sliding roof cover in relation to outer skin of roof.
- Tighten screws (arrows) on retaining brackets (1) on left and right.
- Pull centering bolts (3) out of centering holes on left and right.