Remove/install front bumper - AR88.20-P-2000GX

MODEL 463.202 /222 /236 /237 /270 /271 /303 /306 /336 /340 /341 /346 

Fig 1: Identifying Front Bumper Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove underride guard	If installed.
		Model 463.271	AR88.30-P-0010MG
2	Remove fog lamp	Model 463.270/ 271 up to protection period 31.8.06	AR82.10-P-1835GR
		Model 463.270/ 271 as of protection period 1.9.06 Model 463.202 /222 /236 /237 /303 /306/336 /340 /341 /346	AR82.10-P-1835GY
3	Remove front grille		AR88.00-P-2115GM
4.1	Remove bolts on oil cooler (4) from bumper (2)	Except model 463.202/222/236/237/270/271/306/336/346 Secure oil cooler (4) against falling down.	AR18.30-P-1000MG
4.2	Remove oil cooler (4)	Model 463.306/336/346 Secure oil cooler (4) against falling down. Oil cooler lines remain installed on oil cooler (4)	AR27.55-P-1000GY
5	Remove bolt (1)
6	Disconnect outside temperature sensor connector (B14x1)
7	Remove bumper (2)
8	Install in the reverse order