Remove/install rear bumper - AR88.20-P-2200GL

MODEL 461.302 /304 /305 /331 /332 /333 /334 /340 / 342 /344 

Fig 1: Identifying Rear Bumper Components

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Screws And Stealth Stop Lamp

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
1	Disconnect battery ground line		AR54.10-P-0003GL
	Notes on battery	All models	AH54.10-P-0001-01A
2	Remove left and right bumper corners (1)	To do this, remove bolts (2).
3	Remove rear fog lamp (E3/1)	Disconnect electrical connector, move cable out of bumper toward rear
4	Remove reversing lamp (E7)	Disconnect electrical connector, move cable out of bumper toward rear
5	Unscrew bolts (3) and remove stealth brake light (E4/2)	Vehicles with code (E10) Stealth brake light
		Model 461.305/333/340	AR82.10-P-5390GX
6	Remove bumper	To do this, unscrew bolts (4). The splash guard is fastened to the bumper.
7	Install in the reverse order
8	Read out fault memory and erase	STAR DIAGNOSIS Stored faults which can result from cables being disconnected or from simulation during removal and installation or test work, have to be processed and erased in the fault memories after completing the work.
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A