LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> E350 Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Complete Engine - Testing & Repair - 211 Chassis - 2 Of 3 >> Testing & Repair >> Remove/install cylinder head cover - AR01.20-P-5014 >> Removing/installing the cylinder head cover - AR01.20-P-5014T >> Remove/install cylinder head cover trim - AR01.20-P-5014-02C

Remove/install cylinder head cover trim - AR01.20-P-5014-02C

TORQUE SPECIFICATION CRANKCASE VENTILATION, CYLINDER HEAD COVER

Number Designation Engine 613.960/ 961
BA01.20-P-1002-01A Screw of trim panel of cylinder head cover to cylinder head cover Nm 10
BA01.20-P-1003-01A Screw attaching cover panel to charge air distribution pipe Nm 10
TORQUE SPECIFICATION CRANKCASE VENTILATION, CYLINDER HEAD COVER

Number Designation Engine 648
BA01.20-P-1002-01G Bolt, trim panel of cylinder head cover to cylinder head Nm 9
BA01.20-P-1003-01G Bolt, cover charge air distribution pipe Nm 9
  1. Unscrew bolts (3, 4).

    IMPORTANTInstallation:  Pay attention to tightening torques IMPORTANT .

  2. Pull out trim panel (2) of charge air distribution pipe to the side.

    IMPORTANTInstallation:  Insert plates of trim panel (2) into the rubber mounts (5).

  3. Take off trim panel (1) of cylinder head cover.

    IMPORTANTInstallation:  Ensure the trim panel is correctly installed; ensure no lines are trapped.

  4. Install in the reverse order.
    Fig 1: Identifying Cylinder Head Cover Trim Components
    G04982565
scientia non olet · About LEMON Manuals