Remove/install side trim panel in rear - AR68.30-P-4780T
MODEL 211.2
Shown on left side of vehicle
Shown on left side trim panel
MODIFICATION NOTES
| 8.1.04 | Disconnect/connect/remove ground lead from battery |
| Remove/Install | |||
|---|---|---|---|
| 1 | Remove left and right rear seat cushions | AR91.12-P-1020TB | |
| 2 | Fold down left and right rear seat backrest | ||
| 3 | Unclip left and right cover (1) from load compartment side trim panel (1) with mounting wedge | Figure | |
| 4 | Cut stay on load compartment side trim panel (1) at cutting point (arrow) with sharp knife | ||
| 5 | Remove left and right load compartment side trim panel (1) | AR68.30-P-1180T | |
| 6 | Remove left and right trim from C-pillar | AR68.30-P-4490TA | |
| 7 | Unclip door sill molding (2) from rear entrance with mounting wedge | Figure | |
| 8 | Remove expansion clip (3). | ||
| 9 | Fold back floor covering (4) until nut (5) is accessible | ||
| 10 | Unscrew nut (5) | ||
| 11 | Remove edge guard (6) in area of load compartment side trim panel (1) | ||
| 12 | Remove stop (7) from locking eye (8) | ||
| 13 | Remove bolts (9) | ||
| 14 | Unclip load compartment side trim panel (1) at retaining clips (10) from C-pillar with mounting wedge. | ||
| Figure | |||
| 15 | Remove load compartment side trim panel (1) until electrical connector of load compartment socket (X58/4) is accessible. | ||
| 16 | Disconnect electrical connector from load compartment socket (X58/4) and remove load compartment side trim panel (1). | ||
| 17 | Install in the reverse order |