LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2007 >> E350 Base >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Electrical System - Body - Retrofitting & Conversion - 211 Chassis - 2 Of 2 >> Retrofitting & Conversion >> Retrofit satellite radio (SDAR) - AZ82.60-P-0006T >> Retrofit satellite radio antenna - AZ82.60-P-0006-02T

Retrofit satellite radio antenna - AZ82.60-P-0006-02T

DANGER Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when working with corrosion protection agents. Never spray anticorrosion agents on flames or glowing hot objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection. AS97.00-Z-0001-01A
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1001-07A Zinc dust paint suitable for spot welding A 000 986 34 42
Fig 1: Masking Outer Trunk Lid Area
G04986613
  1. Using paint masking tape, mask off outer trunk lid area where dia. (A) bore will be drilled as per picture (see arrow).
  2. From inside of trunk lid, drill bore with dia. (A) as per picture in center of round breakthrough in reinforcement plate through trunk lid outer panel.

    IMPORTANT When drilling the bore with dia. (A), ensure that the trunk lid outer panel is not deformed and that no other components are damaged. Remove metal shavings using vacuum cleaner.

  3. Deburr bore with dia. (A) and seal on inside and outside using zinc dust paint.

    IMPORTANT Areas to be sealed must be dry and free of grease and dust. The following operation steps can only be performed after the zinc dust paint has dried.

    Fig 2: Inserting Fitting Sleeve From Inside Of Trunk Lid Into Bore
    G04986614
  4. Remove protective foil of bonding surface on fitting sleeve (3) (see arrow in enlarged detail).
  5. Insert fitting sleeve (3) as per picture from inside of trunk lid into bore and glue on.

    IMPORTANT Bonding surface must be dry and free of grease and dust.

  6. Loosen expansion bolt (4) of SDAR antenna (2) until antenna base is loose.
    Fig 3: Inserting Antenna Base Of SDAR Antenna Into Fitting Sleeve
    G04986615
  7. Insert SDAR antenna plug (6) with SDAR antenna line (5) from outside through fitting sleeve in trunk lid.
  8. Insert antenna base of SDAR antenna (2) into fitting sleeve and align straight area of SDAR antenna (2) as per picture in direction of travel (see arrow).
  9. Tighten expansion bolt (4) of SDAR antenna (2) until antenna base is tensioned enough so that the SDAR antenna (2) is firmly flush against the trunk lid and is secured.

    IMPORTANT The SDAR antenna plug (6) will be connected to the SDAR antenna extension line at a later stage.

scientia non olet · About LEMON Manuals