Remove/install rear spring - AR32.20-P-0230T

MODEL 211.08 /09 except CODE (489) Airmatic (semi-active air suspension) 

	Remove/install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Remove rear wheel
	Remove and install wheels		AP40.10-P-4050Z
2	Remove spring control arm cover
3	Detach shock absorber from spring control arm	Push together shock absorber and position at side of spring control arm.	*BA32.25-P-1003-03A
	Risk of injury  caused by pinching or crushing  when working on springs or spring bodies that are under load	Use only approved tensioning devices; shield off hazard area if necessary. Inspect special tools for damage and proper operation (visual inspection). Wear protective gloves.	AS00.00-Z-0001-01A
4	Clamping rear spring	Mark the position of tensioning plates relative to rear spring using oil chalk.	AR32.20-P-0200-06T
	Springs; general background information.		AH32.20-P-9404-01A
		Installation:  Observe oil chalk markings.
5	Install in the reverse order	Installation:  Only tighten bolts and nuts of the chassis components in the curb condition.
6	Check headlamp setting and correct if necessary
	Check and correct headlamp adjustment		AP82.10-P-8260T

REAR AXLE SHOCK ABSORBER