Remove/install oil dipstick guide tube - AR01.45-P-9600T

ENGINE 648.961 in MODELS 211.026 /226 /023 /223 

Fig 1: Identifying Oil Dipstick Guide Tube Components

	Remove/install
	Risk of injury  caused by fingers being jammed or pinched  when removing, installing or aligning hoods, doors, trunk lid/ rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.	AS00.00-Z-0011-01A
1	Open engine hood		AR88.40-P-1000T
2	Remove trim panels of cylinder head cover		AR01.20-P-5014-02C
		Bolt, cylinder head cover trim panel to cylinder head	*BA01.20-P-1002-01G
		Bolt, trim panel to charge air distribution pipe	*BA01.20-P-1003-01G
3	Remove screw (1)	Bolt, exhaust gas recirculation positioner to exhaust gas recirculation cooler	*BA14.20-P-1010-01C
4	Raise vehicle with lifting platform
5	Remove soundproofing bottom section		AR94.30-P-5300T
6	Remove screw (2)	Bolt, oil dipstick guide tube to engine oil pan	*BA01.45-P-1007-01G
7	Pull oil dipstick guide tube (3) out of engine oil pan	Installation:  Replace sealing ring.
8	Install in the reverse order
	Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near the running engine	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts.	AS00.00-Z-0005-01A
9	Run engine and inspect for leaks

CRANKCASE VENTILATION, CYLINDER HEAD COVER

Number	Designation		Engine 648
BA01.20-P-1002-01G	Bolt, cylinder head cover trim to cylinder head	Nm	9
BA01.20-P-1003-01G	Bolt, cover to charge air distribution pipe.	Nm	9

EXHAUST GAS RECIRCULATION

Number	Designation		Engine 646 except 646.8 Engine 647, 648
BA14.20-P-1010-01C	Bolt, exhaust gas recirculation positioner to exhaust gas recirculation cooler	Nm	9.5

OIL PAN

Number	Designation		Engine 648
BA01.45-P-1007-01G	Bolt, oil dipstick guide tube to engine oil pan	Nm	8