Remove/install seal for tilting/sliding roof cover - AR77.20-P-1300TX

MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof 

Fig 1: Identifying Seal For Tilting/Sliding Roof Cover Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove wind deflector		AR77.20-P-2500TX
2	Loosen bolts (6) on front rail (2)
3	Pull seal (1) out of front rail (2), left side rail (3), right side rail (4) and rear rail (5)	Carefully pull seal (1) out of front rail (2), since barbs which could damage the seal (1) are attached to the front rail (2).
	Install
4	Press up front rail (2) and tighten screws (6).
5	Press seal (1) into front rail (2), left side rail (3), right side rail (4) and rear rail (5)	Moisten seal (1) with lubricant. Press in seal (1), first at points marked with arrows, with corrugation up.
		Antifriction agent	*BR00.45-Z-1010-06A
6	Reinstall wind deflector		AR77.20-P-2500TX

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Lubricant, rubber assembly 1 l	A 000 989 03 67