Remove/install paneling on A-pillar - AR68.30-P-4050TX

MODEL 219.3 Upper A-pillar paneling 

Fig 1: Identifying Paneling On A-Pillar Remove/Install Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Paneling On A-Pillar Remove/Install Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Paneling On A-Pillar Remove/Install Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Press edge guard (1) to side in area of A-pillar paneling (2)	Position edge guard (1) on A- pillar paneling (2) with mounting wedge.
			Figure
2	Pivot A-pillar paneling (2) to windshield in direction of inside rearview mirror in upper area	Check whether retaining clips (3) are seated correctly.
3	Remove A-pillar paneling (2) out of instrument panel guide upward
4	Install in the reverse order

Fig 4: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA