Remove/install inside rearview mirror - AR68.40-P-0001TX

MODEL 219.3 

Fig 1: Identifying Inside Rearview Mirror Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Removing
	Risk of injury  Skin, eye and respiratory system irritation may occur through contact or inhalation of substances contained in the mirror lens	Wear protective gloves and safety glasses.	AS60.00-Z-0008-01R
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove overhead control panel control unit (N70)	Allow overhead control panel control unit (N70) to hang down on electrical lines connected.	AR82.20-P-1000TX
2	Disconnect electrical connectors (1, 3)
3	Unclip inside rearview mirror (A67) from mirror support (4)
	Install
4	Press together left spring shackle bolt (5) and right spring shackle bolt (6) using suitable pliers	Ensure that wire retainer (7) secures left spring shackle bolt (5) against springing back (arrow).
5	Connect electrical connectors (1, 3)
6	Clip electrical connector (1) into headliner (2)
7	First position inside rearview mirror (A67) on mirror support (4) using right spring shackle bolt (6). Then arrest mirror support (8) using left spring shackle bolt (5) in mirror support (4)
8	Install overhead control panel control unit (N70)		AR82.20-P-1000TX
9	Program garage door opener transmitter unit	Only when replacing inside rearview mirror (A67) on vehicles with code (231) Garage door opener or code (232) Garage door opener with frequency 284-390 MHz.
	Notes on programming garage door opener transmitter unit		AH68.05-P-0002-01A