Remove/install headlight beam adjustment control unit - AR82.10-P-4081Q
MODEL 209 as of 17.5.05 with CODE (614) Bi-xenon headlamp unit except CODE (P98) Black Series
MODEL 209 as of 17.5.05 with CODE (615) Bi-xenon headlamp unit with integrated curve illumination except CODE (P98) Black Series
Illustrated on model 209.4
Illustrated on model 209.4
| Remove/install | |||
|---|---|---|---|
| Notes on avoiding damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Remove passenger seat | AR91.10-P-1000Q | |
| 2 | Detach edge guard (2) in area of entrance paneling (1) | ||
| 3 | Remove entrance paneling (1) | ||
| 4 | Unclip rear footwell vent grille (6) (arrow) and remove | ||
| 5 | Pull out rear floor covering (7) under the B-pillar paneling (8) | ||
| 6 | Lift up rear passenger compartment floor covering (7). | ||
| 7 | Guide electrical wiring harness (5) out of the rear floor covering (7) | ||
| 8 | Unscrew nuts (10) and remove headlamp range adjustment control unit (N71) | ||
| 9 | Disconnect electrical connector (9) | ||
| 10 | Install in the reverse order | ||
| 11.1 | Check headlamp adjustment | Only when replacing the headlamp range adjustment control unit (N71). | |
| Check and correct headlamp setting | AP82.10-P-8260P |