Remove/install wheel antenna - AR40.15-P-0090SX
MODEL 216, 221 with CODE (475) Tire pressure monitor (Siemens)
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed areas or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | AS83.70-Z-0002-01A | |
| 1 | Turn steering | ||
| 2 | Switch off ignition | ||
| 3 | Open flap (1) on rear fender liner in front fender | ||
| 4 | Detach rear fender liner from front fender at area around wheel sensor | Vehicles with code 228 Stationary heater, when removing right front TPM [RDK] wheel antenna (A2/45) | |
| 5 | Unscrew bolt (2) | ||
| 6 | Remove TPM wheel antenna (A2/44, A2/45) | ||
| 7 | Unlock plug (3) and unplug | ||
| 8 | Install in the reverse order | ||
| 9 | Read out fault memory with STAR DIAGNOSIS and erase if necessary. | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A |