Carry out conditions and tests for chassis alignment - AR40.20-P-0260SX

MODEL 166, 169, 171, 172, 197, 203, 204, 207, 209, 211, 212, 215, 216, 218, 219, 220, 221, 230, 245 

	Checking
1	Check condition of vehicle	For the wheel alignment check all vehicle parts must be installed and the vehicle build completed ready to drive. The vehicle specified values are provided through the measuring system by means of actual values determined. The specified tolerances of vehicle specified values are only for the test. If the vehicle is adjusted, the specified values should be aimed for.
2	Print out form for wheel alignment check	If necessary when an optical chassis alignment is carried out.
3	Check tire condition for wear pattern, tread depth and damage	Perform visual inspection.
4	Check rim condition for damage	Perform visual inspection.
5	Check tire pressure, correct if necessary	See tire inflation pressure chart inside the fuel filler flap.
6	Check vehicle underside for damage, corrosion of suspension parts, chassis parts and supporting body parts, leaks from major assemblies and lines	Perform visual inspection.
7.1	Raise front axle and check wheel bearing play without dial indicator	All except model 197
7.2	Raise vehicle at side at jack support point and check wheel bearing play without dial indicator	Model 197 Never raise vehicle at front or rear axle. Otherwise the axle may be damaged.
8	Checking condition of steering mechanism	Check tie rods, tie rod ball joints and steering coupling.
		Model 216, 221	AP46.00-P-4653SX